Directed Digital System FORD9
© 2016 Directed. All rights reserved.
Quick Reference Guide – Viper, Clifford, Python, Avital & Automate
Vehicle takeover with Get In and Go
1
Close the vehicle doors, hood and trunk, then
press the
Remote Start
button on the transmitter to
start the vehicle.*
Press Remote
Start button*
2
Press the
Unlock
button on the factory or
aftermarket remote.*
Press Unlock on
either remote*
Remove battery
from one key fob
Insert a FOB Key
(without battery)
other key fob
more than
10 feet away
Press UNLOCK
(door button)
+
Key port
2
X
2
X
2
X
OR
Complete the following steps within 45 seconds or the vehicle will shut down.
3
Enter the vehicle, while making sure the factory
remote is inside with you.
Remove batter
y
from one
key fob
Insert a FOB
Key
(without batter
y)
other key fob
more than
10 feet away
Press UNLOCK
(door button)
+
Key port
2
X
2
X
2
X
Enter vehicle
with remote
4
Depress the brake pedal, put the car in gear and
drive off.
Ready to
drive off
* Your aftermarket remote may differ from the model shown in the illustrations.
Get In and Go
Get In and Go is designed to provide users with easy takeover when entering their
Push-to-Start (PTS) equipped vehicle, once it has been remote started.
Typically, users would have to remote start their vehicle, then get inside and press
the vehicle start button to perform a takeover. There is therefore a physical action
required to drive away. With Get In and Go technology, you simply remote start the
vehicle, unlock the doors, get in and go... All that's left to do is put the gear in drive
and enjoy your vehicle.
This unique feature monitors a variety of parameters such as the key fob, vehicle
speed sensor and door sensor, in order to perform takeover securely.
Manual transmission ready mode
1
While the vehicle is running, put the gear in
Neutral
(N).
Put
gear in
Neutral
2
Depress the vehicle’s foot brake.
Depress
brake
pedal
3
Apply the emergency brake.
Apply
emergency
brake
4
Release the vehicle’s foot brake.
Warning!
Depressing the brake pedal again after this
step will disable the remote start feature.
Release
brake
pedal
5
Press any button on the transmitter.* The parking
lights flash 5 times confirming that the remote start
feature is active.
Note
: If the parking lights do not flash 5 times, you
have not entered manual transmission mode and will
need to repeat steps 1 to 5.
Parking lights flash x5
Press any
button*
&
6
Exit the vehicle.
Exit vehicle
7
Press the
Lock
button on the factory or aftermarket
remote.*
The vehicle engine will shut Off after locking
the system.
Press Lock on
either remote*
Remove battery
from one key fob
Insert a FOB Key
(without battery)
other key fob
more than
10 feet away
Press UNLOCK
(door button)
+
Key port
2
X
2
X
2
X
OR
* Your aftermarket remote may differ from the model shown in the illustrations.
