Rev.: 20
914
170
Platform: DBALL2
Firmware TL7
:
© 2017 Directed. All rights reserved.
Not required in D2D mode.
It is important to make sure you do
connect the keysense wire in th
installation or you
NOT
is
will encounter issues when attempting to start the vehicle.
1
8
16
9
Diagnostic
connector OBDII
Remote
Starter
1:
(-) Lock Input
Green:
2:
(-) Unlock Input
Blue:
3:
(-) Trunk Input
Red/White:
10:
(-) GWR (Status) Input
Blue/White:
9:
(+) Ignition Input
Pink:
[4] Autolights Interr. (conn. side):
11
Yellow/Red:
[3]
in 18
(-) Parking Lights: P
[4] Autolights Interr. (veh. side):
10
Orange/Red:
(+) Brake
Output:
6
Status
Gray:
(-) E-Brake Status Output:
1
Black/White:
(-) Door Status Output:
3
Green/White:
(-) Trunk Status Output:
4
Red/Black:
SIL:
10
Yellow/Black:
RDA:
11
Orange/Black:
[ ]
2
(-) Hood Status Output:
12
Blue/Red:
HS CAN
: P
High
in 6
SIL
in 7
: P
RDA
HS CAN
: P
Low
in 14
Headlight
Switch
(+) 12V
(-) Ground
(+) 12V
:
13
Input
Red:
(-) Ground:
14
Black:
(+) 12V Input
(+) Ignition
Output
2
(+) Ignition
Input/Output
1
(+) Starter
Output
2
(+) Starter
Output
1
[3]
Output
(-) Parking Lights
(-) Trunk Status Input
(-) Door Status Input
(-) E-Brake Status Input
[2]
(-) Hood Status Input
(+) Brake
Input
Status
(-) Ground
(-)
Output
Lock
(-)
Output
Unlock
(-) Trunk Output
(-) GWR Output
[4]
: P
Autolights
in 19
Make this connection
only
if the vehicle is
equipped with Automatic
Headlamps.
HS CAN High:
3
Tan/Black:
HS CAN Low:
4
Tan:
Body ECU Connector
Note:
RDA wire is NOT
required in all vehicles.
Refer to vehicle Wiring and
Connector References
Information for wire and
connector details.
Ignition
onnector
C
Fuse Box Connector
Refer to the Vehicle
Wiring
Reference Information
for wire
and connector details.
4 3 2 1
8 7 6 5
1
CUT
Installation Type 1
Page 3
P#: XKD2D65
TX
(-) Ground
RX
(+)12V
10
DBALL/
DBALL2
RF
Prog
utton
. B
LED
4
14
12
2
[ ]
1
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D. Tach is not detected in all vehicles;
refer to the Vehicle Application Guide for compatibility.
[ ]
2
If
equipped
factory
. If not, a hood switch must be installed and connected to the remote starter.
[ ]
3
Parking light output only required if Parking Lights are not supported in data.
With the exception of the
Diagno tic connector, all adapters are displayed from the wire side (unless specified otherwise).
OBDII
s
[4]
Autolights Interrupt only required if vehicles are equipped with Autolights.