© 2000 Directed Electronics, Inc. Vista, CA
35
3.
Choose.
Within 10 seconds, press and release the Valet®/Program switch the number of
times corresponding to the feature number you want to program. (See
Feature Menus
.)
Once the Valet®/Program switch has been pressed and released the desired number of times, press it once more
and
HOLD
it. After a second, the LED will flash to indicate which feature you have accessed. For example, in Menu
Two, groups of eight flashes would indicate access to the status output feature (Feature 2-8). The horn will also
honk eight times (if connected).
4.
Transmit.
The transmitter is used to select the desired setting. As shipped, the unit is con-
figured to the LED ON settings. These are the default settings. Pressing Channel 1 (usually
Button I) will set it to the LED ON setting. The LED will light solid (stop flashing) to indi-
cate the setting. The horn will honk once (if connected). Pressing Channel 2 (usually
Button II) will change the setting to the LED OFF setting. The LED will go out indicating
the change and the horn will honk twice (if connected).
5.
Release.
The Valet®/Program switch can now be released.
For example, to program the arming mode from active to passive, within 10 seconds of turning the ignition off, select
Menu One and press and release the Valet/Program switch once. Then press it again and
HOLD
it. The LED will
flash in groups of one and the horn will honk once (if connected). While
HOLDING
the Valet®/Program switch,
press the Channel 2 transmitter button. The LED will stop flashing and go out. The horn will honk twice if con-
nected. Passive arming is now programmed. If that was not the desired setting, without releasing the
Valet®/Program switch, press the Channel 1 transmitter button. The LED will light solid and the horn will honk
once if connected. Active arming is now programmed. Release the Valet®/Program switch after the selection has
been made.
You can advance from feature to feature by pressing and releasing the Valet®/Program switch the number of times
necessary to get from the feature you just programmed to the feature you wish to access. For example, in Menu
One, if you just programmed Feature 1-2 and you next want to program Feature 1-3 to off, release the
Valet/Program switch. Press and release it once to advance from Feature 1-2 to Feature 1-3. Then press it once
more and
HOLD
it. The LED will flash in groups of 3 and the horn will honk 3 times (if connected) to confirm
that you have accessed Feature 1-3.
The learn routine will be exited if:
■
The ignition is turned on.
■
The Valet/Program switch is pressed too many times.
■
More than 15 seconds elapses between programming steps.
One long horn honk (if connected) indicates that the Learn Routine has been exited.
