32
© 2001 Directed Electronics, Inc. Vista, CA
transmitter/receiver learn routine
The system comes with two transmitters that have been taught to the receiver. The receiver can store up to four
different transmitter codes in memory. Use the following learn routine to add transmitters to the system or to
change button assignments if desired.
When the learn routine has previously been programmed using an optional hand-held system programmer
(
p/n 998T
) or PC Interface module, it may have been locked. Before proceeding with reprogramming the
learn routine, it must be unlocked by using either
p/n 998T
or the PC Interface module - this cannot be done
manually with the Valet switch. If the learn routine is locked, transmitters cannot be programmed to the system.
1.
Open a door.
(The GREEN wire, H1/5, or the VIOLET, H1/7 must be connected.)
2.
Turn the ignition on.
(The YELLOW wire, H1/9 must be connected.)
3.
Select the receiver channel.
Press and release the Valet/program switch the number of
times necessary to access the desired channel. Press and
HOLD
the Valet/program switch
once more. The siren will chirp and the LED will blink the number of times corresponding
to the channel that has been accessed.
CHANNEL
PRESS AND RELEASE
WIRE
NUMBER
THE VALET/PROGRAM SWITCH
TO PROGRAM FUNCTION
COLOR
1
Once
Arm/disarm/panic
2
Twice
Silent Mode/Remote Valet/trunk release
RED/WHITE
3
3 Times
Remote start or other accessories
WHITE/BLUE
4
4 Times
Sensor On/Off or other accessories
VIOLET/BLACK
5
5 Times
Stereo On/Off or other accessories
GRAY/BLACK
6
6 Times
Other accessories
WHITE/BLACK
7
7 Times
Arm only
8
8 Times
Disarm only
9
9 Times
Panic only
10
10 Times
Auto Learn Expanded Configuration
11
11 Times
Auto Learn Standard Configuration
12
12 Times
Delete all transmitters
*NOTE:
For Auto Learn Configurations, see Transmitter Configurations section of this guide.
