Directed Electronics Clifford 2.2, Owner'S Manual

Page: 31 / 52

31 © 2008 Directed Electronics. All rights reserved.
➤
Valet take-over
The Valet take-over feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful for
occasions when you wish to exit and lock the vehicle for short periods
of time, but would like to leave the motor running and the climate
controls on.
To perform Valet take-over:
Before turning off the engine, press and release 1.
AUX
on the trans-
mitter. Then wait a few seconds.
Turn the ignition key to the OFF position (The engine will stay
2.
running).
The engine will run until the pre-programmed time elapses or a
3.
shut-down input is received.
Note:
To enable Valet take-over with a manual transmission, open the
door and enter into manual transmission mode, as described above.
The parking lights flash five times when entering Valet take-over. Once
you exit the vehicle you can lock the system and the car will remain
running. If the vehicle shuts down when locking, then the unit did not
enter valet take-over mode.