Directed Electronics AVITAL 3001L, Owner'S Manual

Page: 21 / 24

17
© 2009 Directed Electronics
QUICK REFERENCE GUIDE
To arm the system
■
You can arm the system by locking the doors with your factory keyless
entry transmitter. When the system arms, you will hear a short siren
chirp, and see the parking lights flash once.
To disarm the system
■
To disarm the system, unlock the doors using your factory keyless trans-
mitter. You will hear two siren chirps, and the parking lights will flash
twice. If the siren chirps more than twice when disarming, your system
may have triggered while you were away. See Table of Zones information
on back.
Disarming without a transmitter
■
Turn on the ignition. Press and Release the Valet switch the pro-
grammed number of times within 10 seconds. Default is 1. Possible set-
tings are from 1 to 5. The system should now disarm. If it does not, you
may have waited too long. Turn the ignition off and on and try again.
To enter or exit Valet Mode
■
Turn ignition to “run” position, then turn to “off” position. Press and
Release the Valet switch within 10 seconds. The status LED will light
solid if you are entering Valet Mode, and it will go out if you are exit-
ing Valet Mode.
Note: System must be disarmed to enter Valet mode.
Remote Valet
®
■
Open any door. Press the lock button on your transmitter. Within one
second, Press the unlock button on your transmitter. Within one sec-
ond, Press the lock button on your transmitter again. The status LED
will stay on if you have entered Valet Mode, and it will go out when exit-
ing Valet Mode.
Cut along dotted line and f
old f
or a quick and eas
y r
efer
ence to k
eep in y
our pur
se or w
allet.
✂✂
✂ ✂