4
46
6
© 2004 Directed Electronics, Inc. Vista, CA
3
3--8
8 A
ACCTTIIV
VA
ATTIIO
ON
N P
PU
ULLSSEE CCO
OU
UN
NTT:: This allows the system to use 1 or 2 pulses to activate the remote start sequence.
N
No
ottee!! 1 or 2 pulses on the WHITE/BLUE remote start activation input wire as well as the
button of the remote control.
3
3--9
9 2
2n
nd
d IIGGNNIITTIIOONN//22nndd AACCCCEESSSSOORRYY OOUUTTPPUUTT:: This will allow the PINK/WHITE to be used as a 2nd ignition or an
accessory.
3
3--1
10
0 A
ACCCCEESSSSO
OR
RY
Y SSTTA
ATTEE D
DU
UR
RIIN
NG
G W
WA
AIITT--TTO
O--SSTTA
AR
RTT:: This feature will allow the selection of the accessory output to
be ON or OFF during wait-to-start.
3
3--1
11
1 2
2n
nd
d SSTTA
ATTU
USS O
OU
UTTP
PU
UTT:: This feature will allow selection of status output or a rear defogger mode that turns
on ten seconds after the vehicle has started. The defogger mode has two selections, latched or pulsed. Latched
mode will only stay on for 5 minutes.
3
3--1
12
2 A
AN
NTTII--G
GR
RIIN
ND
D O
ON
N//O
OFFFF:: With the anti-grind On (default) the ground-when-armed output will be active during
remote start operation. If accessories such as a voice module or window module are added to the unit, it may be
necessary to program this feature off.
nnuuiissaannccee pprreevveennttiioonn cciirrccuuiittrryy
™
™
NPC™ requires that you change the way you test the system as NPC™ will bypass an input zone for 60 minutes.
If the system “sees” the same zone trigger three times AND the triggers are spaced less than an hour apart, the
system will bypass that input zone for 60 minutes. If that zone does not attempt to trigger the system during
the 60-minute bypass period, the zone’s monitoring will begin again at the end of the hour. If it does attempt
to trigger while bypassed, the 60-minute bypass starts over again.
Disarming and rearming the system does not reset NPC™. The only way to reset NPC™ is for the 60 minutes to
pass, without a trigger, or for the ignition to be turned on. This allows the system to be repeatedly triggered,
disarmed and rearmed, and still allow NPC™ to bypass a faulty zone.
When disarming the system, 5 chirps indicate NPC is activated. The LED will report the zone that has been
bypassed. (See
Diagnostics section of this guide.)
