1
18
8
© 2004 Directed Electronics, Inc. Vista, CA
This input comes from the factory set to 2 activation pulses. This means that it is necessary to have 2 consecu-
tive ground pulses on the white/blue wire for the remote start to activate or to deactivate. The same holds true
for the remote control activation when set to a two pulse setting it is necessary to press the
button twice
for the remote start to activate or deactivate.
N
NO
OTTEE:: When the activation pulse count has been programmed to 1 or 2 pulses it will affect both
activation inputs; the White/Blue wire and the remote control activation.
Connect this wire to the optional domelight supervision relay as shown below:
IIM
MP
PO
OR
RTTA
AN
NTT!! This output is only intended to drive a relay. It cannot be connected directly to the
domelight circuit, as the output cannot support the current draw of one or more light bulbs.
Most vehicles use negative door trigger circuits. Connect the green wire to a wire which shows ground when any
door is opened. In vehicles with factory delays on the domelight circuit, there is usually a wire that is unaffected
by the delay circuitry. This wire will report Zone 3.
H
H1
1//5
5 G
GR
REEEEN
N ((--)) d
do
oo
orr ttrriig
gg
geerr iin
np
pu
utt,, zzo
on
nee 3
3
H
H1
1//4
4 B
BLLA
ACCK
K//W
WH
HIITTEE ((--)) 2
20
00
0 m
mA
A d
do
om
meelliig
gh
htt ssu
up
peerrvviissiio
on
n o
ou
uttp
pu
utt
H
H1
1//3
3 W
WH
HIITTEE//B
BLLU
UEE rreem
mo
ottee ssttaarrtt ((--)) aaccttiivvaattiio
on
n iin
np
pu
utt
