16
© 2003 Directed Electronics, Inc. Vista, CA
Before connecting this wire, remove the supplied fuse. Connect to the battery positive terminal or the constant
12V supply to the ignition switch.
NOTE:
Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 10A fuse
in the harness for this purpose. This fuse is intended to protect the module.
When the system receives the code controlling Channel 2, for longer than 1.5 seconds, the RED/WHITE wire will
supply an output as long as the transmission continues. This is often used to operate a trunk/hatch release or
other relay-driven function.
IMPORTANT!
Never use this wire to drive anything except a relay or low-current input! The transistorized output can
only supply 200 mA of current. Connecting directly to a solenoid, motor, or other high-current device will cause it
to fail.
H1/12 RED/WHITE Channel 2, (-) 200 mA output
H1/11 RED (+)12V constant power input
