Direct Nexus MDS-1001, Manual

Page: 29 / 35

TROUBLESHOOTING
26
TROUBLESHOOTING
PROBLEM CAUSE REMEDY
Nothing happens
when the power
switch is turned on.
Is the power plug
plugged into an
electrical outlet?
Control that the plug is inserted in an
electrical outlet. Unplug and insert the
plug back if necessary.
No nebulization
is performed or
nebulization rate
is low,when the
power is on
Is there medication in
medication cup?
Is there too much/little
medication in the
medication cup?
Is the baffle missing
and not assembled
correctly?
Is the nebulizer kit
assembled correctly?
Is the nozzle blocked?
Is the nebulizer kit bent
at a sharp angle?
Is the air tube
connected correctly?
Is the air tube folded
or damaged?
Is the air tube clogged?
Is the air filter dirty?
Is the air filter cover
attached correctly?
Is the compressor
covered?
Are the ventilation slots
blocked?
Add the correct amount of medication
to the medication cup.
Attach the baffle correctly
Assemble the nebulizer kit
correctly.
Make sure that the nozzle is
free of blockages
Make sure that the nebulizer kit is not
tilted at an angle of more than 45 degrees.
Make sure that the air tube is correctly
connected to the compressor and nebulizer kit.
Make sure that the air tube is not
bent in an angle that it disturbs airflow.
Make sure that the air tube is free of clogging.
Replace the air filter with a new one
Attach the air filter cover correctly.
Do not put any covers on it while in operation
Do not block the ventilation slots
The compressor
is abnormally loud.
The compressor
is very hot