www.dipol.biz
7
adjustment handle (10) to turn to brightness adjustment mode
(inscription Gain ХХ in the message line changes to BRGT. ХХ). Choose an
optimal brightness level of micro display by rotating handle. Brightness
adjustment varies from 0 up to 25.
7. Use of the device
with additional accessories
There is an opportunity in the device to connect outer power source with
10…14,6 V (car embedded network) through the slot (8) or outer power
source with 8-14,5 V and plug of JACK 2.1. standard.
To record image you should use standard video cable with RCA plug
to connect the binocular and corresponding plug for the used video
recording device. When the binocular is switched on (first position of
switcher 4) video is given to the plug (9).
You may switch off microdisplays during video mode by rotating the
switcher (4) to the next position. When recording the image, guide
yourself by the instructions (menu) of video recording device.
Video type given from the binocular to video recording device is CVBS.
8. Possible defects
and methods of their removal
Your binocular is a complex optomechanical device. Its repair and service
may be fulfilled only in conditions of manufacturer.
If switch-on indicator doesn’t shine or blink after switching- on the
binocular, and image is absent or blinks in the eyepiece, so may be power
elements are uncharged or junctions in battery compartment are broken.
Change power elements; inspect junction at the battery compartment
cap (3) and junction inside the battery compartment.
There shouldn’t be any corrosion traces and any dirtying. If power
elements are changed and junction cleaning doesn’t help, if any other
defects or failures appear, don’t try to disassemble the binocular by
yourself and repair it. It may lead to greater failures and warranty loss.
Turn to the vendor or to the manufacturer.
Summary of Contents for TG1
Page 11: ...www dipol biz 11 For notes...
