us.diono.com/installation-videos
1-855-463-4666
44
45
7. Locate the LATCH Strap in the
Forward-Facing Belt Path.
Thread LATCH strap through the
forward-facing belt path (marked
with the red label) and out the
other side. The LATCH anchors are
easier to feed through by pulling
forward on the front cover as
shown.
8. Attach LATCH Connectors to
Vehicle’s Lower LATCH Anchors
and listen for audible click to
confirm engagement.
LATCH strap should lie flat and not
be twisted.
9. Tighten the LATCH Strap
Press down firmly in the center of
the car seat while tightening the
LATCH strap. You may need to
tighten through the opening in the
pad at the belt path as shown, by
pulling it through and up.
FOR
W
ARD F
A
CING
10. Tighten the Top Tether Strap
Push the car seat back while
tightening the tether strap to
remove all the slack.
11. Test for Tightness
Grab the side of the seat with one
hand where the LATCH strap is and
slide the car seat side-to-side and
front-to-back. If the seat moves
less than 1 inch (2.5 cm), it is tight
enough. Do not test by grasping
top of the seat.
12. To Remove LATCH Strap From
Vehicle
Push in on the red buttons on the
LATCH connects and pull them off
the anchor bars.
FOR
W
ARD F
A
CING