DAG1000/2000 Series FXS/FXO Voice Gateway User Manual
5
Dinstar Technologies Co., Ltd.
If the target IP address is 192.168.0.160, the dialing convention is
*47,
then
192*168*0*160.
Followed by pressing the “#” key or wait 3 seconds. Complete
signaling interactive soon after, he was called the unit can be heard ringing.
【
Note
】
：
You cannot make direct IP calls between FXS0 to FXS1 since they are using same
IP. It only supports the default destination port 5060.
2.2 Call Hold
Place a call on hold by pressing the “flash” button on the analog phone (if the phone has
that button).Press the “flash” button again to release the previously held Caller and resume
conversation. If no “flash” button is available, use “hook flash” (toggle on-off hook quickly).
You may drop a call using hook flash.
2.3 Call Waiting
Call waiting tone (3 short beeps) indicates an incoming call, if the call waiting feature is
enabled. Toggle between incoming call and current call by pressing the “flash” button. First
call is placed on hold. Press the “flash” button to toggle between two active calls.
2.4 Call Transfer
2.4.1Blind Transfer
Blind transfer used to transfer call to the third party without inform caller. Assume that call
Caller A and B are in conversation. A wants to Blind TransferB to C:
1
）
Caller A presses
FLASH
on the analog phone to hear the dial tone;
2
）
Caller A dials
*87
then dials caller C’s number, and then # (or wait for 4 seconds);
3
）
Caller A will hear the confirm tone. Then, A can hang up.
Note
：
“
Call features enable
” must be set to “Yes” in web configuration page. Caller A can place a
call on hold and wait for one of three situations:
