22
G Adjustment method in this example only apply to the state that when these two curves
move in parallel and uniform deviation, useless when temperature up and down in
disorder
H Location of galvanic couple inside the upper blow-dryer: take down the blow-dryer,
cover in the couple 2-3cm away from the blow-dryer
I Please according to relevant correct operation; avoid to be burnt by high temperature!
8
Use the same theory, paste the outer galvanic couple on the bottom of PCB board, that
is the right above of bottom dryer, only reserve lower heating (turn off the upper
heating), can measure and correct the accuracy of lower heater
9 Statement: Turn off the upper heater (set the data relevant to upper heater to be 0)
(Remark: This machine take the upper heating time as benchmark to set other segments,
so when start lower heating alone, set the upper temperature to be 0, first segment of
upper constant time should be set to larger than or equal to total lower heating time)
10 Matters to be attention please refer above 7th relevant details
11 Adjusting methods in details are as below:
A If the electric dipole measuring curve (light blue) is lower than actual temperature curve (green), can
adjust Electric dipole probe in the hair dryer to downward
B If the electric dipole measuring curve (light blue) is higher than actual temperature curve (green), can
adjust Electric dipole probe in the hair dryer to upward
