6
www.dimplex.com
Icon
Function
Description
F
360
o
Light
Press multiple times to change the LEDs on the sides and back of the unit from
Midnight mode to white to yellow to red. (The middle segment on the display will
change through 0 - 3 respectively. This feature is active only when the Flame is
ON.)
G
Timer
Press multiple times to change the sleeper timer in 0.5 hr increments from 0.5 hr
to 8.0 hr before turning off. The remaining time on the sleep timer displays.
H
Light
Sensor
Press to activate the ambient light sensor (ALS ON). Press again to turn the
sensor off (ALS OFF).
!
NOTE:
The light sensor will adjust the brightness of the fireplace based on
the ambient light in the room.
I
Brightness
Press to change the LED lights from High to Low. (The last segment on the
display will change from "H" to "L") The Realog
TM
LEDs remain On when the
heater is ON and the flame effect is Off.
!
NOTE:
When the Light Sensor is activated, High and Low flickering
brightness settings are also available (Flashing "H" and "L").
J
Heat Mode
Press the multiple time to toggle through the heat modes (Normal, Eco and
Boost). Normal is indicated with a Nor on the display, ECO is indicate by an Eco
on the display and Boost is indicate by a b20 on the display. In boost mode, a
time is set initial for 20 minutes and the display will indicate b19, b18, etc., as the
time counts down. This is shown by pressing the heat mode button.
K
Temp Up
Press multiple time to raise the heater temperature in 1
°
F (1
°
C) increments.
Displays current temperature; highest temperature is 99
°
F (37
°
C). This feature is
active whenever the heat is enabled.
Change Fahrenheit (
°
F)
to Celsius (
°
C)
Press both Temp+ (
) and Temp– (
) on the unit.
Heat Enable
Heat Disable
Hold both Heat (
) and Temp– (
), on the unit, for 2 seconds. Temperature
displays on the screen.
Hold both Heat (
) and Temp– (
), on the unit, for 2 seconds, when
temperature is adjusted "---" displays on the screen.
L
Heat
• Heat On
Press to turn heat On (indicated by 1 short beep and the icon appearing on the
display). Displays current heater temperature setting. Use the Temp Up/Down
icon to change the heater temperature setting.
•
Heat Off
Press to turn heat Off (indicated by 1 short beep).
!
NOTE:
After the heater is switched off, the fan will continue on for 60
seconds before turning off.
Control Lock
Control Unlock
Hold both Temp– (
) and Brightness (
), on the unit, for 2 seconds to
disable the manual controls.
Hold both Temp– (
) and Brightness (
), on the unit, for 2 seconds to enable
the manual controls.
