11
6.2.2 Remote control
The wall-mounted remote control (Fig. 7) enables the HPWH to be switched on and off as well any one of the
three fan speed settings to be selected (see Table).
Slide switch
Description
1
Hot water preparation by heat pump
* a
nd fan On /Off
2
Selection of fan speed (fan setting = 95 m³/h, II = 185 m³/h, III = 300 m³/h)
The remote control is surface-mounted. To facilitate
connection, it is recommended that the housing be installed
over a flush box (mounting instructions are supplied with the
remote control).
The connection between HPWH and remote control is to be
effected by customers using a 6-pole connecting lead (see
section "Electrical connection").
* Heat pump operation cannot be activated or deactivated
from the remote control unless the "heat pump" switch was
activated on the unit beforehand.
Note: Continuous operation of the electric heating element
cannot be controlled via remote control (see section 5.3 "External
immersion heater control")
In switch position I it is
possible to activate a
supplementary heat source
"Heat exchanger" switch
*
Switch position O
Æ
heat pump is
OFF , in switch position
å
å
å
å
/
the heat pump is in operation
"Heat pump" switch
In switch pos. I the immersion heater is
continuously switched on, in pos. the
immersion heater is in the automatic mode
"Immersion heater" switch
Temperature display see above
1
2
Fig. 7 : Remote control
Fig. 6: Operating panel
( *
shown is the operating panel of
the HPWH with internal heat
exchanger; on HPWH without internal
heat exchanger the "heat exchanger"
switch is dispensed with )
