5. L.E.D. DISPLAY
Indicates the current room temperature or the time setting. If it’s
adjusted by the user the display will return to the pre-set temperature
automatically.
6. SPEED
Press to select LOW, MEDIUM, HIGH or AUTO fan speed.
If "AUTO" is selected, the unit operates at maximum cooling
capacity when the room temperature less the setting temperature
is above 2
℃
.
When the room temperature less the set temperature is below
2
℃
, the unit operates at middle cooling capacity.
When the room temperature equal the set temperature, the
unit operates at minimum capacity.
If "HIGH" is selected, the unit operates at maximum cooling
capacity regardless of the pre-set temperature. Similar operation is
applied when "MEDIUM" OR “LOW" is manually selected.
7. PROGRAMMABLE
Programmable timer ON/OFF key.
TIMER
TIMER-ON: The timer-on key is used to turn the unit on
automatically when the set time is reached.
(The indicator light will be turned on when the timer is
functioning.)
1. Press the "TIMER" key at stand-by status to set the time.
Choose the function desired (refrigeration, heat or
dehumidification.)
2. Once the set hour has come to an end, the unit will turn on
automatically.
3. If you press the “POWER” key before the timer is complete, the
set time will be cancelled and the unit will remain turned on.
TIMER-OFF: The timer-off is used to turn the unit off automati-
Error Display
E1: Indicates open circuit or short circuit in room temperature sensor.
E2: Indicates open circuit or short circuit in pipe temperature sensor.
E7: Indicates the water is full inside.
Please contact an authorized service centre if any of the above error messages are shown
.
cally after the set time is over.
8. SLEEP CONTROL
When setting the "sleep comfort" mode please ensure that you
FUNCTION
then set the number of hours required and press the timer
button till those hours are indicated on the L.E.D display. After
setting the hours the L.E.D. display will automatically return to
the current pre-set temperature. To increase this setting press
the "UP" button and for each press, the temperature will be
increased by 1
℃
. Likewise to set for a lower temperature, press
the “DOWN” button and for each press, the temperature will be
decreased by 1
℃
.
During the course of this cycle, to ensure maximum sleep
comfort, the micro-processor memory will raise the pre-set
temperature 0.5
℃
each half hour to a maximum of 2
℃
over two
hours and then maintain that temperature for the balance of the
time set.
The portable air conditioner is fitted with a 3 minute compressor
delay protection circuit which simply means that the compressor
requires 3 minutes to start. From either being switched on, or
when changing from “dehumidify” to any air conditioning cycle
chosen.
9.”E7”
When the unit warns of full water, please unplug the water
stopper at the back of the unit and then lean the unit to drain the
water out. Then the unit can be restarted. If the error: E7 is
presented again, please find a specialized person to repair.
Note: Heating function does not operate if the ambient temperature is over 23
℃.
Cooling function does not operate if the ambient temperature is over
43
℃.
(Heating function is only available in the following models:
GDC12RCWA / GDC12RCBA /
GDC14RCWA / GDC14RCBA)