Dimensions (millimetres)
Model Specification
DXC20TIE7: 2.0kW convector heater with electronic controls
DXC30TIE7: 3.0kW convector heater with electronic controls
DXC30FTiE7: 3.0kW convector heater with electronic controls and
turbo boost
Electrical Connection
WARNING: THIS APPLIANCE MUST BE EARTHED
The use of an extension lead or multi-plug adaptor is not adviced when connecting this product to the mains. Connection through these
deviced could lead to risk f overloading, overheating and even fire at the extention lead or adaptor due to inadequate connection quality
This heater must be used on an AC (~) supply only and the voltage marked on the heater must correspond to the supply voltage. This
heater is fitted with a rewirable plug incorporating a a 13 amp fuse. In the event of replacing the fuse in the plug supplied, a 13 amp fuse
approved by ASTA to BS 1362 must be used. If any other type of plug is used, a 15 amp fuse must be fitted in the plug, the adaptor, or at
the distribution board.
IMPORTANT: If the plug is not suitable for your socket, the 13 amp plug should be removed. Before wiring the appropriate plug, please note
that the wires in this mains lead are coloured in accordance with the following code:
GREEN AND YELLOW:
EARTH
BLUE:
NEUTRAL
BROWN:
LIVE
Connect the GREEN AND YELLOW wire to the terminal marked ‘E’ or by the earth symbol, or coloured GREEN or GREEN AND YELLOW.
Connect the BROWN wire to the terminal marked ‘L’ or coloured RED. Connect the BLUE wire to the terminal marked ‘N’ or coloured
BLACK
230
MIN
695 - 3.0kW
575 - 2.0kW
418
150
450
MIN
350
250
MIN
Technical Data
Model Identifier(s)
DXC20TIE7
DXC30TIE7
DXC30FTIE7
Heat output (kW)
Nominal heat output
Pnom
2
3
3
kW
Minimum heat output (indicative)
Pmin
2
3
3
kW
Maximum continuous heat output
Pmax,C
2
3
3
kW
Auxillary electricity Consumption
At nominal heat ourput
elmax
0.00
0.00
0.00
kW
At minimum heat output
elmmin
0.00
0.00
0.00
kW
In standby mode
elSB
0.00
0.00
0.00
kW
Tubo Fan
N
N
Y
Contact details
Glen Dimplex Heating and Ventilation, Millbrook House, Grange Drive,
Hedge End, Southampton, SO30 2DF
WARNING: DO NOT USE THE HEATER UNTIL THE FEET OR WALL BRACKETS ARE FITTED CORRECTLY
The product can be used as an installed or portable unit. Once the desired application has been decided upon and the requirements below have
been met the product is ready to be used. Simply plug in and switch on at the wall socket.
There are various control options available with various combinations via the membrane buttons and segmented display. Please note - the
element has been coated with a protective film which will burn off during the first few minutes of use and may cause a small amount of fuming.
This is quite normal - the fumes are non-toxic and will quickly disappear. We recommend that you open a window to ventilate the room when
using the heater for the first time.
Using the Heater
