6
www.dimplex.com
!
NOTE:
A 15amp, 120 volt
alternating current (VAC) circuit
is required. A dedicated circuit
is preferred but not essential in
all cases. A dedicated circuit will
be required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when the
heater is operating. Additional
appliances on the same circuit
may exceed the current rating of
the circuit breaker.
WARNINg:
Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of fire, electric shock or injury to
persons.
Construction and electrical
outlet wiring must comply with
local building codes and other
applicable regulations to reduce
the risk of fire, electric shock and
injury to persons.
Do not attempt to wire your own
new outlets or circuits. To reduce
the risk of fire, electric shock or
injury to persons, always use a
licensed electrician.
IMPORTANT SAFETY INSTRUCTIONS
Stove Installation
Make sure the units MAIN
1.
ON/OFF switch is switched
OFF (refer to operating in-
struction section).
Plug the unit directly into a
2.
15Amp/120volt outlet.
