Dimplex CHESIL CLS20, Owner'S Manual

Page: 4 / 4

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
NZ
Chesil
Model: CLS20
Manual Controls - see Fig. 2
Three switches provide a choice of heat setting. Each switch is
activated when the bottom half of the switch is pushed in.
Switch 1 Controls the electricity supply to the heater.
Note: This switch must be in the ON position for the
heater to operate with or without heat.
Switch 2 Provides 1kw heat output.
Switch 3 Provides 2kw output when used in conjunction with
switch 2
Removing Optional PanelFig.3.
Step A. Remove the screw on the leg shown in Fid.3. Action A.
and repeat on the other side. Action B. is to turn the Fitting Anti
Clockwise until the small arrow faces up. Action C is to remove
the panel by Pulling down. When the Optional Panel is removed
unscrew the fitting that was holding the panel on. Please store in
a safe place incase you wish to put this panel back on, or wish to
return the Suite.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.
Light Emitting Diode
This fire is fitted with LED (Light Emitting Diode) bulbs in place
of conventional bulbs . These generate the same light levels as
conventional bulbs, but use a fraction of the energy consumed.
These LED bulbs are maintenance – free and will not require
replacing during the life of the product.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive
cleaners. The glass viewing screen should be cleaned carefully
with a soft cloth. DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush
attachment of a vacuum cleaner should occasionally be used to
clean the outlet grille of the fan heater.
Three switches provide a choice of heat setting. Each switch is
activated when the bottom half of the switch is pushed in.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive
cleaners. The glass viewing screen should be cleaned carefully
with a soft cloth. DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush
attachment of a vacuum cleaner should occasionally be used to
clean the outlet grille of the fan heater.
Three switches provide a choice of heat setting. Each switch is
activated when the bottom half of the switch is pushed in.
Recycling
For electrical products sold within the European
Community. At the end of the electrical products
useful life it should not be disposed of with
household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer
for recycling advice in your country.
Model Number
The Model & Serial number of your product is displayed on the
rating plate at the rear of your product, you should have this
information to hand when contacting customer service.
After Sales Service
Your product is guaranteed for one year from the date of purchase.
Within this period, we undertake to repair or exchange this product
free of charge (excluding lamps & subject to availability) provided
it has been installed and operated in accordance with these
instructions.
Your rights under this guarantee are additional to your statutory
rights, which in turn are not affected by this guarantee.