Dimplex BFL50-EU, Owner'S Manual

Page: 9 / 70

9
Mark the location of four (4) 5.
screw locations on the wall
(through key-holes).
CAUTION: If installing unit on
a wall that is constructed of
drywall ensure that appropriate
wall anchors are used and at
least one is located into a stud.
Remove fireplace from wall 6.
and store in a safe place
away from traffic.
Screw all four (4) supplied #8, 7.
3.8 cm square head mounting
screws and washers into
the wall and/or wall anchors
leaving 6.5 mm of thread.
Align chosen key-holes with 8.
screws and hang fireplace
on the wall. Screw heads
and washers will fit through
key-holes and fireplace will
slide down into place (screws
will slide into narrow part of
key-holes).
Tighten all four (4) mounting 9.
screws down on fireplace
chassis.
Screw the two (2) supplied 10.
#8 square head screws
through two of the permanent
mounting holes which align
with a wall stud.
Carefully replace and install 11.
Lay fireplace on its back. •
Remove two (2) Phillips •
screws from each of the two
(2) glass brackets (Figure 2).
Remove glass brackets. •
With one hand keeping •
pressure on the partially
reflective glass, tilt the
fireplace upright and slightly
forward to allow the partially
reflective glass to fall out of
the inside framing.
Remove partially reflective •
glass from fireplace.
Position the fireplace on a wall 4.
at the position where it will be
mounted (Figure 3). Use a
bubble level (one is supplied)
to ensure that fireplace is level
on the wall.
Fireplace Installation
Figure 3
Key-hole
Wall stud
Permanent
mounting hole