Dimplex BFL50-EU, Owner'S Manual

Page: 7 / 70

7
Site Selection
Review and consider all of the
following conditions for installation:
Dimensions of the unit: 128cm •
x 49.5cm
Unit requires a minimum of two •
(2) wall studs in order to ensure
a secure installation
Three possible installation
methods:
Installation method: Surface •
mount; In-wall Recessed; or
Flush mount
Hardwired or plug-in method
•
WARNING: Ensure the power
cord is not installed so that it
is pinched or against a sharp
edge and ensure that the
power cord is stored or secured
to avoid tripping or snagging to
reduce the risk of fire, electric
shock or injury to persons.
Construction and electrical
outlet wiring must comply
with local building codes and
other applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
Select a location that is not 1.
susceptible to moisture and
is away from drapes, furniture
and high traffic.
Fireplace Installation
For ease of electrical 2.
hook up you may wish to
locate the fireplace near an
existing outlet (for plug-in
convenience).
!
NOTE 1: A 13 Amp, 230 Volt
circuit is required. A dedicated
circuit is preferred but not
essential in all cases. A
dedicated circuit will be
required if, after installation,
the circuit breaker trips or
fuse blows on a regular basis
when the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
Remove fireplace, front 3.
glass and hardware from box
and remove all packaging
materials before installation.
Store the fireplace in a safe, 4.
dry and dust free location until
you are ready to install the
fireplace.