Dimplex AC3CE, Instruction Manual

Page: 7 / 40

General
The carton contains:-
• 1 x AC3CE heater
• 1 x Wireless remote
This Recessed Ceiling Heater / Over Door Heater is a robust heater intended for
installation into a suspended or plasterboard ceiling.
For optimum results, do not install this product in ceilings higher than 3 metres. If
multiple heaters are installed, generous spacing should be provided between heaters
to achieve an even heating distribution.
Electrical Connections
The electrical connection of this product should be carried out by a competent
electrician and be in accordance with the current IEE wiring regulations.
Only cable with a minimum CSA (cross sectional area) of 2.5mm should be used for
this appliance.
A suitable local isolating switch must be provided in the electrical supply circuit with
at least 3mm clearance on each pole.
WARNING:
Ensure power cable path does not come into contact with internal heater elements or fans. Make
connections as per wiring Diagram (see Fig. 3) and close the grill.
Connection of Heater
Gain access to the terminal block (see ‘x’ in Fig. 2) by unlocking the grill by moving
the two slides in the direction of the arrows (see ‘A’ in Fig. 2) as shown using a small
screwdriver or other suitable tool. Open the grill and feed the appropriate cable
through the cable gland (see ‘Y’ in Fig. 2)
Fig. 2
7