Dilog DCT-280, Operating Instructions Manual

Page: 59 / 71

25
• Network Search: Choose „On“, if your Search is to include all Transponders,
that are connected to a certain Network.
Use the NAVIGATION Keys LEFT and RIGHT to toggle between „On“ and „Off“.
• Search Range: Use the NAVIGATION Keys LEFT and RIGHT to toggle
between All Channels, Free-To-Air or Scrambled Channels.
• Logical Channel: By setting the option to „On“ the sequence of channels in your
channel list changes according to what has been determined by your operator.
Should your network not provide this function, please switch this option to „Off“.
In Automode the Search begins with
the Start frequency and ends
with the End frequency, the set
Frequency steps, the set Symbolrates
(6111,6875 and 6900ksps) as well as
the set Constellation (16,32,64,128 and
256QAM) is used.
Depending on the Cablenetwork it
cannot be guaranteed that in
Automatic mode all channels are
actually found.
To start the channel Search enter the following values and then press the RED
key.
• Start frequency: Set the Start frequency for the channel search using the OK-
and numerical keys on your remote control.
• End frequency: This Search value defines the End of the Search Range. A
reduction of the range results in a faster search however, possibly results in less
channels being found.
• Frequency lists: This extended Search parameter changes the Grid Resolution
of the Search. Please only change the value if you are familiar with this function.
• Search Range: Use the NAVIGATION Keys LEFT and RIGHT to toggle
between All Channels, Free-To-Air or Scrambled Channels.
• Logical Channel: By setting the option to „On“ the sequence of channels in your
channel list changes according to what has been determined by your operator.
•
Should your network not provide this function, please switch this option to „Off“.