11
1. Check your antenna connection.
2. Drive your vehicle over 20mph for 3 to 5 minutes. This will
“wake” the transmitter and begin to transmit a signal to your
display unit.
If the display unit is working properly and it still does not receive a signal from
the transmitter(s), then the transmitter(s) and ID module(s) must be replaced
simultaneously.
A replacement transmitter and ID module can be purchased from a Dill
distributor or retailer, list available at www.trailertpms.com.
3.7 Antenna Installation (Optional) and RF Interference*
If the display unit is receiving a signal on an intermittent basis, i.e. when the
distance is greater than what is recommended or there is interference
preventing a continuous signal reaching the display from the wheel, you will
need to install an exterior antenna. The added benefit of an exterior antenna is
to assure a better reception from your transmitters to the display/receiver.
The antenna is assembled with an industrial strength magnet, 19 feet of coaxial
wire, and a coaxial connector to install into the back of your display/receiver.
19’ COAXIAL
WIRE
DISPLAY/RECEIVER
CONNECTOR
ANTENNA
MAGNET
NOTE: MAGNETIC
STRENGTH WILL ADHERE
QUICKLY TO ANY METALLIC
OBJECTS. KEEP FINGERS
AWAY FROM THE BOTTOM
OF THE MAGNET.
