Digium, Inc.
Page 34
Chapter 2: Card Installation
1.
After the machine has booted to Linux, log in and execute the
following command to list the devices detected by the PCI bus:
# lspci -n
Confirm that the output from lspci lists a device with Digium’s PCI
vendor ID which is “d161”. The screen output should be similar to the
following:
0000:01:0e.0 ISDN controller: Unknown device
d161:<card identifier>
Note: The output from lspci may or may not state “Unknown
device”. If it does, this does not indicate a problem.
In the PCI device listing shown above, <card identifier> will be
populated with one of the identifiers listed in the table below.
