8
4.2. Hot Key Operation
When using the Hot Key sequences, the keys must be pressed within 6 seconds,
otherwise the Hot Key action will terminate.
The Hot Key Operation is only supported under Microsoft Windows series system.
4.2.1. PC Selection
[ScrollLock] + [ScrollLock]
→
change the active PC port.
Hot Key
Action
[ScrollLock] + [ScrollLock]
Switch active PC connection to the next PC
Disclaimer
Information in this document is subject to change without notice. The manufacturer does not make any representations or warranties
(implied or otherwise) regarding the accuracy and completeness of this document and shall in no event be liable for any loss of profit
or any other commercial damage, including but not limited to special, incidental, consequential, or other damages.
No part of this document may be reproduced or transmitted in any form by any means, electronic or mechanical, including
photocopying, recording or information recording and retrieval systems without the express written permission of the manufacturer.
All brand names and product names used in this document are trademarks, or registered trademarks of their respective holders.
FCC Statement
This device generates and uses radio frequency and may cause interference to radio and television reception if not installed and used
properly. This has been tested and found to comply with the limits of a Class B computing device in accordance with the specifications
in Part 15 of the FCC Rules. These specifications are designed to provide reasonable protection against such interference in a
residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this device does
cause harmful interference to radio or television reception, which can be determined by plugging the device in and out, the user can try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the device and receiver.
Connect the computer into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
