Digitus DN-170093, Quick Installation Manual

Page: 2 / 81

2
1. Important safety warning
Important safety instructions – Save these instructions
Please comply with all warnings and operating instructions in this manual strictly.
Save this manual properly and read carefully the following instructions before
installing the unit. Do not operate this unit before reading through all safety
information and operating instructions carefully.
There exists dangerous voltage and high temperature inside the UPS. During the
installation, operation and maintenance, please abide the local safety instructions
and relative laws, otherwise it will result in personnel injury or equipment damage.
Safety instructions in this manual act as a supplementary for the local safety
instructions. Our company will not assume the liability that caused by disobeying
safety instructions.
1.1 Transportation
•
Please transport the UPS system only in the original package to protect against
shock and impact.
1.2 Preparation
•
Condensation may occur if the UPS system is moved directly from cold to warm
environment. The UPS system must be absolutely dry before being installed. Please
allow at least two hours for the UPS system to acclimate the environment.
•
Do not install the UPS system near water or in moist environments.
•
Do not install the UPS system where it would be exposed to direct sunlight or near
heater.
•
Do not block ventilation holes in the UPS housing.
1.3 Installation
•
Do not connect appliances or devices which would overload the UPS system (e.g.
laser printers) to the UPS output sockets.
•
Place cables in such a way that no one can step on or trip over them.
•
Do not connect domestic appliances such as hair dryers to UPS output sockets.
•
The UPS can be operated by any individuals with no previous experience.
•
Connect the UPS system only to an earthed shockproof outlet which must be
easily accessible and close to the UPS system.
•
Please use only VDE-tested, CE-marked mains cable (e.g. the mains cable of your
computer) to connect the UPS system to the building wiring outlet (shockproof
outlet).
•
Please use only VDE-tested, CE-marked power cables to connect the loads to the
UPS system.
•
When installing the equipment, it should ensure that the sum of the leakage
current of the UPS and the connected devices does not exceed 3.5mA.