DigiTech RP70, Owner'S Manual

Page: 22 / 48

16
Applying Power
Before applying power to anything, set your amp(s) to a clean tone and set the tone controls to
a flat EQ response (on most amps, this would be 0 or 5 on the tone controls). Then follow the
steps listed below.
Turn the amp volume all the way down.
Connect the plug of the PS200R power supply to the power jack on the rear panel of the
RP70.
Connect the other end of the PS200R power supply to an AC outlet. Use the
Master
Level
button and the
Value Up/Down
buttons to set the RP70’s Master Level to “0”.
Turn the power of your amplifier(s) to the on position and adjust the volume(s) to a nor-
mal playing level.
Use the Master Level button and the Value Up/Down buttons to gradually increase the
RP70’s Master Level to achieve the desired volume.
4. Turn amp volume up
1. Turn amp volume down
2. Connect PS200R to power jack
3. Connect PS200R to AC outlet
and set the RP70’s Master
Level to “0”
5. Set the RP70’s Master Level to the
desired listening volume
1.
2.
3.
4.
5.