DL-UHDRC70 Quick Guide
Package Contents
•
(1) DL-UHDRC70 HDBaseT TRANSMITTER
•
(1) DL-UHDRC70 HDBaseT RECEIVER
•
(1) DC18V 1A Power Adapter
•
(2) Phoenix 3.5mm 3 pin Male Connectors
•
(1) IR emitter
•
(1) IR eye
•
(4) mounting brackets
Connectivity Instructions
1. Verify all components included are present before installation.
2. Connect an HDMI source device to the HDMI IN port on the transmitter using
an HDMI cable
3. Connect a display device to the HDMI OUT port on the receiver using an HDMI
cable
4. Connect Category 6 or greater twisted pair cable with RJ45 connectors
between the transmitter and the receiver. TIA/EIA-568B straight-through wiring
connections must be used with the DL-UHDRC70
5. Connect control system / devices to the RS232 port on the transmitter and
receiver for serial pass through.
6. Both the transmitter and receiver has an IR IN and an IR OUT for bi-directional
IR control. Connect one device with an IR emitter to the IR OUT then the other
device should be connected with an IR eye into IR IN to pass IR control
7. Apply power to DL-UHDRC70 by connecting the 18V power supply to either the
transmitter or receiver. Powering one unit will power the other via PoC
Note
: On the front panel of the TX/RX check to make sure the
Power, Status,
HDCP
&
Link
lights are all illuminated on both units. This will indicate a successful
connection with a lit
HDCP
light illustrating the presence of encryption within the signal.
Power
and
Link
are static lights and
Status
should be blinking.
Tx
RXD
GND
Rx
TXD
DL-UHDRC70 TX or
DL-UHDRC70-RX
Controller or
Device
Summary of Contents for DL-UHDRC70
Page 2: ......
