DL-SE3H1V-C Owners Manual
10
Connecting Control
RS232 Control Wiring
Connect the DL-SE3H1V-C receivers LAN port to an Ethernet control network for telnet control.
Connect the DL-SE3H1V-C RS232 port on the receiver for serial control.
Relay Port Wiring
Apply Power
Plug the power supply into the power input port on the rear of DL-SEH1V-C receiver The receiver will power
the transmitter via HDBaseT. Twist the locking ring clockwise to prevent accidental disconnection of power.
Note
: The DL-SE3H1V-C RS232 port can either be used with a control system for serial
control of the DL-SE3H1V-C transmitter and receiver or can be connected to an external
display for ON/OFF display control using telnet control.
For complete list of control commands see pg13
RS232 and TCP/IP Control
Tx
RXD
GND
Rx
TXD
DL-SE3H1V-C
RX
Controller or
Device
Connect the controller or device RX signal to TX port of the DL-SE3H1V-C receiver. Then connect the controller or device
TX signal to the RX port on the DL-SE3H1V-C receiver.
For the normally open contacts (NC), connect a circuit between
the NO and COM terminals of the 3-pin
For the normally closed contacts (NC), connect a circuit be
-
tween the NC and COM terminals of the 3-pin phoenix connec
-
tor
I/O STATE
RELAY STATE
NO
NC
ON
CLOSED
OPEN
OFF
OPEN
CLOSED
