6
Installation -
Installation
Before installing your camera, you have to read the following cautions.
1.
The mounting surface must support five times the camera weight.
2.
Protect the cables. If the cover of the electrical line becomes damaged, this may cause a short or fire.
3.
Pass the wires through and make all necessary connections. See page 9 for more information.
4.
Install the ferrite core on the LAN cable to reduce high-frequency noise:
•
Open the ferrite core by lifting the closing clip.
•
Make one loop with the cable through the ferrite core.
•
Close the ferrite core to hold the cable loop in place.
Concealed installation:
(Camera is mounted BEHIND the mounting
surface, with the lens peeping through)
1. Drill a hole (diameter: 0.11”/ 3mm) on the mounting
surface where the camera lens will be installed.
2. Peel off one side of the double-sided tape included
with the camera and attach it to the flat surface of
the pinhole cover. Aligning the grooves on the tape
with the screw holes on the pinhole cover.
3. Peel off the other side of the tape and stick to the
mounting surface. Align the pinhole cover and the
mounting surface, keeping the top screw at the top
of the pinhole cover upright.
4. Secure the pinhole cover to the mounting surface
using the tapping screws (M3x20) included with the
camera.
5. Pass the camera’s cable through the cable holder
on the pinhole cover and place the camera module
inside the pinhole cover. The camera lens should be
facing the mounting surface, aligned with the 1mm
hole drilled in #1. Tighten the top screw head to fix
the camera module in place.
6. Use the cable clamps to secure the camera’s cable
with a tapping screw (M4x20) included with the
camera (optional).
Tape