Net-2000™ Voice Codec Unit
User’s Manual
Page 2
DVSI Confidential Proprietary
Section 1 – Net-2000™ VCU Introduction
Set-up
The Ethernet interface is equipped to handle IP address information from a DHCP server so that
initial set-up of the Net-2000™-P25 VCU is fast and straightforward. Alternatively, the RS-232 serial
port can be used via telnet as a console terminal to allow low-level network setup.
Control
When connected on a LAN — any PC on the network can use a standard web browser to control the
Net-2000™-P25 VCU through the use of a PC web browser. The user-friendly web pages built-into
the Net-2000™-P25 make it easy to select analog audio interfaces, select the vocoder mode and to
establish real-time, full-duplex communication across the Ethernet connection. In addition to the
control, the web pages display information about network settings, operating mode and system
status. Since the Net-2000™-P25 uses Ethernet, its web page can even be accessed over a
wireless network through a wireless notebook or tablet PC.
Protocol
The Net-2000™ VCU uses DVSI’s own UDP interface described in section 4. This allows users to
develop their own application controls and user interfaces for an endless array of customized
applications.
Before using the Net-2000™- P25 VCU, read through this user’s manual in its entirety, paying
careful attention to the safety instructions beginning on page ii.