Digital Monitoring Products XR20, User Manual

Page: 19 / 52

Arming and Disarming XR20 User’s Guide 15
Instant Arming
Instant
: During the exit delay time, you can cancel the exit and
entry delays and cause all zones to be instant zones. Press the
far right select key under INSTNT while the exit delay displays.
This immediately arms the exit zones. However, no entry delay is
provided and an alarm immediately occurs should an entry door be
opened.
All/Perimeter Shortcut Key Arming
Arm Perimeter —
Press 6 for 2 seconds.
Arm All—
Press 1 for 2 seconds.
Arming an All/Perimeter System
1. Enter your code. The keypad displays PERIM ALL .
2. Select PERIM to arm the Perimeter area only.
3. Select
ALL
to arm both the Perimeter and Interior areas.
4. The keypad displays zones that have been bypassed prior to
arming and zones that are now in a faulted condition.
5. At this point you can force arm or bypass any faulted zones.
A zone that is force armed is restored into the system if it
later returns to normal. A bypassed zone remains bypassed
until the system is disarmed. See steps 5a through 5d.
5a. If a problem exists on any zones, the zone name and
problem display followed by:
OKAY BYPASS STOP
.
5b. Select OKAY to force arm the zone(s) before arming.
5c. Select
BYPASS
to bypass the zone(s) before arming.
5d. Select
STOP
to stop the system from arming. Correct
the zone problem(s) and return to step 1.
6. The keypad displays
PERIMETER ON
if only the perimeter is
being armed and ALL SYSTEM ON if both the perimeter and
interior are being armed.
7. The keypad next displays EXIT: ## INSTNT and begins to
count down the number of seconds remaining for you to exit.
When the delay expires, all zones are armed.
8. You can select INSTNT while EXIT: ## INSTNT displays to
immediately arm all zones and make them instant. The
keypad displays
INSTANT
. When you select
INSTANT
, any
entry/exit zone that trips immediately activates an alarm
and the exit delay countdown immediately stops.
9. When the system is fully armed, the keypad displays
PERIMETER ON for perimeter arming and ALL SYSTEM ON
for perimeter and interior arming.
All/Perimeter System Disarming
Disarming : While the system is armed, you can only enter the
premises through an entry/exit delay door without causing an
alarm. After opening the door, the Security Command™ keypad
sounds a prewarn tone to remind you to disarm the system. You
must disarm the system before the prewarn tone expires or an
alarm on the door zone occurs.
During the prewarn tone, the keypad displays
ENTER CODE: . Enter
your user code to disarm the system.
Note : Your system may be pre-programmed at installation to silence
the tone as soon as the first user code digit key is pressed. If a valid
user code is not entered within 5 seconds or an invalid user code is
entered, the prewarn tone begins sounding again.
Alarm Display
: After disarming, the keypad dis plays any zones
that tripped or any transmission problems that occurred dur ing
the armed period. All burglary zones are then dis armed and any
by passed zones automatically reset.