Digital Monitoring Products
1100DI Wireless Receiver Installation Guide
2
1100DI Wireless Receiver Installation Guide
Digital Monitoring Products
3
Installing the Optional Mounting Bracket
The following instructions cover installing the receiver using the included mounting bracket. If the installation
does not require the mounting bracket, refer to Installing the Receiver behind the Keypad or Installing the Receiver
without the Mounting Bracket.
1. Secure the mounting bracket using the supplied screws or double-sided tape.
2. Remove the cover from the plastic housing by squeezing both sides toward each other.
3. Connect the receiver to the panel keypad bus using the supplied 4-wire harness. Route the wires through the
opening in the back of the housing.
4. Snap the cover back in place.
5. Line up the receiver base with the mounting bracket snap connectors and press the housing into place.
Snap Connectors
Wall Mount
Screw Hole
Wall Mount
Screw Hole
Figure 2: Optional Mounting Bracket
Installing the Receiver without the Mounting Bracket
These instructions cover installing the receiver without the mounting bracket. If the installation requires the
mounting bracket, refer to Installing the Receiver behind the Keypad or Installing the Optional Mounting Bracket.
1. Remove the cover from the plastic housing by squeezing both sides toward each other.
2. Connect the receiver to the panel keypad bus using the supplied 4-wire harness. Route the wires through the
opening in the back of the housing.
3. Snap the cover back in place.
4. Secure the receiver housing to the wall in the desired location using the supplied double-sided tape.
Programming the Panel
Refer to the XRSuper6/XR20/XR40 Programming Guide (LT-0305) as needed. In System Options, program the House
Code (1-50). In Zone Information, program the wireless zones.
1100DI Receiver Operation
The 1100DI receiver automatically sends the panel house code to wireless transmitters when the unique transmitter
serial number is programmed into the panel. The house code identifies the panel, receiver, and transmitters to each
other. The receiver only listens for transmissions using the specified house code and/or programmed transmitter
serial number.
Note: When setting up a wireless system, it is recommended to program zones and connect the receiver before
installing batteries in the transmitters.
Transmitters can be programmed for supervised or unsupervised operation. When programmed as supervised, the
transmitter must communicate with the receiver within the programmed number of minutes. If the transmitter fails
to communicate, the panel displays a missing condition.
Note
: When a receiver is installed, powered up, or the panel is reset, the supervision time for transmitters is reset.
If the receiver has been powered down for more than one hour, wireless transmitters may take up to an additional
hour to send a supervision message unless tripped, tampered, or powered up. This operation extends battery life for
transmitters. A missing message may display on the keypad until the transmitter sends a supervision message.
When any wireless zone programming is changed in the panel, receiver zone programming is updated when exiting
panel programming. During the update, all wireless zones display as normal for approximately one minute,
regardless of the actual state of the wireless device(s).
