Digital Equipment RapidPrint 500, Reference Manual

Page: 154 / 192

Set/Define Server Subnet Mask
11 - 36
Restrictions You must be the privileged user to use this command.
Parameters host:filename
Used to load from a TCP/IP host via TFTP. Enter a TCP/IP hostname or
IP address followed by a colon and a startup file name of up to 11 charac-
ters in length.
node::filename
Used to load from a VAX machine via LAT. Enter the nodename followed
by two colons and the startup file name of up to 11 characters in length.
node\sys:\login\filename
Used to load from a Novell fileserver. Enter a node name, path, and star-
tup filename of up to 11 characters.
None
Clears any previously configured startupfile name, host, and retry set-
ting.
Retry num
Specifies how many times to retry the download attempt. If zero is speci-
fied, the server will retry indefinitely until the startupfile is read.
Examples
Local> DEFINE SERVER STARTUPFILE “bob:start” RETRY 6
Local> DEFINE SERVER START hevax::start.com
Local> DEFINE SERVER STARTUPFILE engfs\sys:\login\start.cmd”
See Also Set/Define Server Loadhost ; Reloading Operational Software ; Configura-
tion Guide .
11.74 Set/Define Server Subnet Mask
Sets an IP subnet mask for the server, or overrides the subnet automatically created when the IP
address was configured for the server. The mask is applied to target IP addresses to determine
whether the destination address is on the local network segment. If it is not, the server’s gateway
host will be accessed to provide the connection.
Restrictions You must be the privileged user to use this command.
Parameters mask
Enter a mask in numeric IP format. A zero in any bit position prevents
that bit from passing while a 1 in any bit position allows the bit to pass
through.
Examples
Local> SET SERVER SUBNET MASK 255.255.192.0
See Also Set/Define Server IPaddress ; Set/Define Server Gateway ; TCP/IP ; IP
Address .
SET
DEFINE
 
 
 
SERVER SUBNET MASK
[ ]
mask