DSP2022-S SCSI Disk Drive Installation Guide
9
Provide SCSI Bus Termination
The SCSI bus only needs termination resistors at the
beginning and end of the bus. Since this drive does not
have a SCSI bus terminating resistor on it, bus terminating
resistors must be located external to the drive. The drive
does provide power for an external terminating resistor over
SCSI connector pin 24. Leave jumper 7 in place to enable
the drive terminator power supply. Remove jumper 7 if you
don’t need SCSI bus termination.
Obtain a Mounting Kit
Due to the large number of possible installation cabinets
and slot sizes, your drive does not come with an installation
kit of brackets, screws, and cables. You must obtain the
parts needed for your particular installation from your
distributor or purchasing source.
Locate the Drive Mounting Holes
Two holes are provided on each side of the drive for side
mounting. Four mounting holes are provided on the bottom
surface for bottom mounting. These mounting holes are
shown in Figures 3 and 4.
Figure 3
Side Mounting Holes
M3 x 0.5
BOTH SIDES
.740 in
18.80 mm
.244 in
6.20 mm
1.500 in
38.10 mm
1.375 in
34.93 mm
CXO-3496A-MC_R
MOUNTING HOLE (2)
