Connect hubs or station.
To connect two hubs . . .
a.
Set the Ring In and the Ring Out Autowrap
switches to 1 to enable Autowrap.
b. Connect the repeater’s Ring Out port to
the Ring In port of the repeater in the
adjacent hub. Also connect the repeater’s
Ring In port to the Ring Out port of the
repeater in the adjacent hub.
c.
Once the ring becomes active, verify that
the Ring In and Ring Out LEDs are on.
To use as a lobe extender . . .
a.
Set the Ring In and the Ring Out
Autowrap switches to 1 to enable
Autowrap.
b. Connect the station to the Ring Out port.
c.
Once the ring becomes active, verify
that the Ring Out LED is on.
Installing a Repeater in a DEChub 900 MultiSwitch (continued)
6
DECrepeater 900TL
Install the repeater on the hub.
PK–02570–IL
a.
Align the repeater’s 48-pin
connector with any available 48-pin
slot in the hub.
b. Place the repeater’s bottom
mounting tab into the mounting slot
on the hub.
c.
Pivot the repeater into place. You
hear a click when the repeater is
seated.
d. Press down on the release lever to
ensure that it is locked.
e.
With power on in the hub, verify that
the Power, Module OK, and Speed
LEDs are on. If there is traffic on the
network, the Ring A or B LED will
also be on.
PK–02570–IL
The release lever is
lifted and clicks
back into place
as the module
is seated.
LKG–8258-93I
Mounting
tab
LKG–8152-93I
Note:
Before installing the module in a hub, verify that the
module’s input power rating does not exceed the
available power that the Hub Manager LCD displays.
