14
When attaching the HDD to the PS-3651A
The following is the setting method of system information to make BIOS recognize the
hard disk correctly.
3
Hardware Setup
• Normally, the factory default settings should be used.
• Certain BIOS screen items may differ from those shown here due to
new versions or the PS-A unit you are using.
IDE I/F
(1) Turn off the power switch of the PS-A
unit, remove the power cable. Put the
PS-A on the horizontal place while the
display side of it is downside.
(2) Unscrew the screws (3) of the IDE
cover and remove the IDE cover. Plug
the HDD unit cable connector in the
IDE’s interface (Seen the figure on the
left).
(3) Install the HDD unit like the left
figure, and fix it with the screws (4)
which are contained in your package.
The torque strength for the fixing
should be a range of 0.5 to 0.6 N•m.
(4) Place the IDE cover back and fix it
with the screws (3) of the IDE cover.
Summary of Contents for PS-3650A Series
Page 20: ...20 Memo ...
