Digital Electronics GP-2401 Series, User Manual

Page: 57 / 139

Chapter 4 - Transfer Screen Data
4-2
GP-2401/2501/2601 Series User Manual
1* Here, the term “Set up” refers to the process of sending GP screen, system
program and protocol program information to the GP via the screen creation
software, so that the GP can be used as an operator interface.
Transfer screen data from your PC, via the GP screen creation software.
For details about the GP screen creation software, refer to GP-PRO/
PBIII for Windows Operation Manual (included in the GP screen editor software)
To Transfer Data to a Completely New GP
Connect the GP to your PC via the data transfer cable, and then turn the GP ON. The
“Initial Start Mode” screen will appear on the GP and you can transfer screen from your
PC. The screen will change to the “Transfer” screen automatically.
During data transfer, the “SETUP Transfer” and “Now Transferring - Please Wait”
messages will appear. When these messages disappear, screen data transfer is com-
pleted.
If you wish to stop data transfer, simply cancel it from your PC’s GP screen creation
software.
If you try to set up the GP after data transfer, the OFFLINE mode’s “Main Menu” will
appear. If you do NOT set up the GP, the screen designated in “INITIAL SETTINGS/
SCREEN SETUP/INITIAL SCREEN FILE NO. ” will appear and the screen will
change to operation (RUN) mode.
After Completing Data Transfer using GP setup
*1
Transfer screen data from the GP screen creation software, and select the “Transfer” mode.