Digital Electronics GP-2401 Series, User Manual

Page: 136 / 139

GP-2401/2501/2601 Series User Manual 8-7
Chapter 8 - Maintenance
8) Connect the backlight's one (1) power
connector. Next, close the circuit board
and secure the rear case in place using
the attachement screws removed in
steps 1), 2) and 3).
5) Disconnect the backlight's one (1)
power connectors.
6) Loosen the backlight unit attachment
screw. Next, slide the backlight in the
direction shown and lift it forward and
remove it from the GP.
7) Insert the new backlight in the GP. In-
sert the unit by sliding it in the direc-
tion shown in step 6), then, tighten the
unit’s attachment screw.
• Be sure not to pinch or cut any of
the GP unit's internal wiring when
closing the case.
• If any of the attachment screws be-
comes misplaced, check to be
sure that they have not fallen in-
side the GP. If a screw has fallen
inside the GP, do not connect the
unit’s power cord until it has been
removed.
Connector
Attachment Screw