6.3 Backlight Replacement
FP3700-T41 User Manual
6-6
5) Pull out the cable in the direction
shown by the arrow.
The entire backlight unit
should be changed, not just
the backlight.
6) Insert the new backlight unit into the
backlight holder.
7) Secure both backlights in place using the
backlight screws. The necessary torque
is 0.147N·m (1.5kgf·cm).
8) Connect the backlight power cable to the
Invertor board’s backlight connector.
Fix the cable in place inside the cable
clamp, and cover the cable with the
Inverter Insulation Sheet. (Reverse of
step 3)).
Be sure the cable is inserted
completely into the backlight
connector. Failure to do so
may cause arcing, which can
damage the connector.
Be sure to always change
both of the FP backlights at
the same time.
9) Replace the rear cover and secure it in
place using the eight (8) attachment
screws.
The cable clamp is used to
prevent the cable from being
caught inside in the FP unit
and possibly damaged. Be
sure to secure the cable
clamp around the cable before
replacing the rear cover.
Cable
Backlight Unit
Backlight Unit Insertion Point
