10
User manual
– Digital Devices Max S8
18. Mai 2015
9.3.3
Single cable reception (EN 50494/50607)
Enable this option if you want to use a Max S8 for the reception at a single cable system. The settings
for single-cable reception systems according to EN50494 and EN50607 are configured for the Max S8
exclusively in this menu. (The menu item
"Tasks -> Single cable reception"
is not to be used for the
Max S8.)
Select under
„Manufacturer“
the manufacturer of your
LNB or Multiswitch. Subsequent
In next select under
"Device (Switch/LNB)"
your model. If your manufacturer or model is not in the
list, you can select a different model, if it uses the same frequencies and is not pin Protected, or
select the option
"Other Manufacturers"
from the drop down box.
All tuners that can be configured for single-cable reception will be listed, under
"Tuner"
. Over
"Slot"
you can assign the appropriate frequencies for each tuner.
»Note: Single cable reception systems are known by names like: Unicable® - UniCable II® Jess® - SCR
(Single Cable Routing) - single-cable solution. If your single-cable multiswitch / LNB have a
“pin protected” option, you must enter the PIN for the appropriate frequency. This option is
available only if your multiswitch or LNB has the "Pin Protected" option. Usually the PIN
defined by the LNB or Multiswitch and can be found in the user guide.
