FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment dose cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-
Consult the dealer or an experienced radio /television technician for help.
Warning :
You are cautioned that any changes or modifications to the equipment
not expressly approved by the party responsible for compliance could void your
authority to operate such equipment
.
—
NOTE: This unit was tested with shielded interface cables for the connection to the
host PC. The shielded interface cable must be used with the unit to insure compliance
DOC CLASS B NOTICE
This digital apparatus does not exceed Class limits for radio noise emission for a
digital apparatus as set out in the Radio Interference Regulations of the Canadian
Department of Communications
.
