Digital Ally, Inc. | Installation Instructions
3-2
1.
Slide the new rearview DVM (Digital Video Mirror) onto the existing windshield mounting plate
and secure your DVM to the vehicle windshield. For some 2011 - 2013 Dodge vehicles, attach
and orientate the optional adapter to factory windshield as shown. Use Loctite™ to secure the
adapter to the factory windshield mount. If needed, attach optional drop down bracket as
shown.
2.
Use a #20 Torx screw driver to tighten the mounting screw.
3.
Adjust the viewing angle for the rearview mirror.
In some vehicles, the position of the manufacturer’s windshield mounting plate may
not allow for proper rearview DVM adjustment for some individuals, especially when
the vehicle is equipped with an overhead console and/or interior emergency lighting.
In these cases, the mounting plate included with the DVM-LiVE package must be
glued to the windshield in a location that will allow proper adjustment. Loctite
#03346 glue is recommended. Please follow instructions on their package
4.
The unconnected end of the DVM shielding strap must be securely connected to the vehicle
chassis. The strap should be routed and attached to the metal structure above the windshield.
The shielding strap must be connected to a metal surface of the vehicle chassis to
prevent EMI and RF interference. Failure to properly connect the shielding strap may
cause system operation issues.
5.
If the optional Big Ball Mount Kit (002-05102-00) was purchased, attach to the DVM as shown
below. Do not over tighten the hex locking screws in the middle of the Big Ball mount or the
DVM may break off the windshield when adjusted. Follow the instructions included in the kit.
6.
Remove the protective film covering from the
internal Passenger facing camera.
Step 2:
DVM Installation
