Page 6 of 6
Connecting to an Ethernet Network
The
Ethernet 10/100
connector allows the unit to be attached to a
standard Ethernet 10/100 network.
•
Plug a Cat5 cable into the RJ-45 connector labeled
Ethernet
10/100
and connect the other end to a 10/100 switch
•
The
Ethernet 10/100
connector supports auto “MDIX” and can
be plugged directly into a PC for diagnostic purposes
Connecting Power
External Power
•
The 2.1mm Power Jack (center tip positive) accepts
9VDC
PoE
Plug a Cat5 cable from an 802.3af compliant switch or injector into the
Ethernet 10/100
connector. 7 watts will be requested from PoE
(802.3af compatible) Power Source Equipment (PSE).
Connecting Mic In or Audio Out
Mic In
•
The 3.5mm
Mic In
jack accepts a standard electret or dynamic
mic. Use of this jack overrides the integrated mic
•
Mono Jack required
Audio Out
•
The 3.5mm
Audio Out
Jack is capable of driving headphones or
an external amplifier. Use of this jack overrides the integrated
speaker
•
Mono Jack required
Setting Volume Levels
The IP7 Desktop supports seven volume levels for the internal speaker.
•
Press the “Volume Up” or “Volume Down“ button one time to
increase or decrease the speaker volume
•
Pressing the “Volume Up” or “Volume Down “ button seven times
sets the unit at its highest or lowest setting
•
Refer to the software manuals for setting the volume via
software
