14
Copyright © 2009 Digispider. All rights reserved.
www.digispider.net
CHAPTER 3 BASIC OPERATION
Hardware of CFM conference mixer can provide various forms of audio ports,
LED/LCD display and all of the function setup can be customized by the
command of NSP-100 software via network. CFM can be used independently
separated from NSP-100 software after the very moment of successfully
confirming parameter setup.
According to different application situation, it can divide into two modes: stand
alone mode and network mode
STAND ALONE MODE
CFM can work in stand alone mode, controlled by dedicated NSP-100 software.
Recommend to use this mode in small conference discussion system (the
number of microphone less than 10 and number of mixer less than 6)
In stand alone, connect the computer network card to the CFM -1006, whose
functions are controlled via dedicated software NSP-100, with cross-over cable.
The operation is listed below.
Step 1
Connect the computer network card to the CFM -1006 with cross-over cable,
conference microphone to the Line/Mic IN ports at the rear panel and output
equipment to the LINE OUT ports. The maximum length of the CAT-5 cable is
100m.
Step 2
Startup CFM, and wait for CFM start to work in normal status with all LCD and
indicator lights turn light.
Step 3
Add the CFM into the software NSP-100 in a right way, please refer the NSP-100
user’s manual and CFM quick start guide.
Step 4