DG-BG1100N User Manual
42
Bridge Interface
You can choose Activated or Deactivated.
Connection
To control the time of connecting to the internet. You can choose
Always On (Recommended), Connect On-Demand (Close if idle
for xx minutes) or Connect Manually.
TCP MSS Option
You can keep the default value 0 or set a tcp mss value. The
range is from 100 to 1452.
Default Route
Choose the current PVC as the default PVC, and it works in the
routing mode. You can enable or disable default route.
Get IP Address
You can choose Static or Dynamic.
Static IP Address
When Static is selected, you can enter the IP address for dial-up,
which is provided by your ISP.
IP Subnet Mask
When Static is selected, you can enter the IP subnet mask for
dial-up, which is provided by your ISP.
Gateway
When Static is selected, you can enter the gateway IP for dial-up,
which is provided by your ISP.
NAT
Select it to enable Network Address Translation (NAT) function. If
you do not select it and you want to access the Internet normally,
you must add a route on the uplink equipment. Otherwise, the
access to the Internet fails. Normally, it is enabled.
TCP MTU Option
You can keep the default value 0 set a TCP MTU value. The range
is from 100 to 1500.
Dynamic Route
You can select RIP1, RIP2-B and RIP2-M.
Direction
You can select None, Both, IN Only and OUT Only.
Multicast
You can choose Disabled or Internet Group Management Protocol
(IGMP) v1, IGMP v2 or IGMPv3.
Click PVCs Summary besides the field Virtual Circuit, and the following figure appears. You
can view the information summary of each PVC.
