DG-WU2008 User Manual
23
4.4 AC Management
The wireless controller can discover peer wireless AP regardless of whether these devices
are connected to each other, located in the same Layer 2 broadcast domain, or attached to
different IP subnet. When the controller discovers and validates AP, the controller takes
over the management of the AP. You can replace AP configuration by AP Profile template
created on the controller.
NOTE: By default AP will be in FAT Mode. You need to set it in FIT Mode to get it
discovered on controller.
4.4.1 AP List
AP List displays the online/offline wireless AP list.
You can do the following settings under this tab:
Restart AP:
Restart the selected AP from the list.
Reset AP:
Restore selected AP to factory default. (If AP is in FIT Mode,
after reset it will be in same mode)
Delete AP
: Delete the chosen wireless AP from the list.
Apply Configuration Template:
You can push the respective model configuration
template created on controller to desired AP from the list
Refresh:
Refresh the displayed AP List.
