Digisol DG-FS4528P, Management Manual

Page: 701 / 973

– 701 –
30
P
OWER OVER
E
THERNET
C
OMMANDS
The commands in this group control the power that can be delivered to
attached PoE devices through RJ-45 ports 1-24 on the switch.
The switch’s power management enables total switch power and individual
port power to be controlled within a configured power budget. Port power
can be automatically turned on and off for connected devices, and a per-
port power priority can be set so that the switch never exceeds its
allocated power budget. When a device is connected to a switch port, its
power requirements are detected by the switch before power is supplied. If
the power required by a device exceeds the power budget of the port or
the whole switch, power is not supplied.
power mainpower
maximum allocation
This command defines a power budget for the switch (i.e., the power
available to all switch ports). Use the no form to restore the default
setting.
S
YNTAX
power mainpower maximum allocation watts
watts - The power budget for the switch. (Range: 37-180 watts)
D
EFAULT
S
ETTING
180 watts
Table 97: PoE Commands
Command Function Mode
power mainpower
maximum allocation
Sets the maximum power available to all switch ports GC
power inline
compatible
Provides power to pre-standard PoE devices GC
power inline Turns power on and off for specific ports IC
power inline maximum
allocation
Sets the maximum power available to specific switch
ports
IC
power inline overload-
auto-recover
Automatically recovers a port providing power after a
powered device has overloaded
IC
power inline priority Sets the priority for power supplied to specific ports IC
show power inline
status
Displays the current status of power management on
specific ports or all ports
PE
show power
mainpower
Displays the current status of power management for
switch
PE